![]() ![]() You want to remove them so they do not get caught in anything important like the window track, then you may be doing a window regulator replacement as well. If this happens, you can usually get to them with a magnet. Also be careful with the small nuts as it is possible to drop them down into the door panel. Now you can remove the 3 nuts and the mirror, be sure to have a helper hold the mirror form the outside so it does not fall down onto the door and scrath it.Next locate and unplug the electrical connector if you have a power mirror.You may see a foam piece of insulation or a piece of insulating tape, remove whichever you have to see and access the 3 nuts that hold the mirror in place, see the picture. Look at the inside of the door panel, direclty whee the mirror is attached.You have just done the hardest part of this job, now you simply unbolt and unplug the mirror and install the new replacement.Step 3, Remove & Replace the mirror assembly: ![]() You will not be able to see this until you remove the panel from the door. NOTE: Their may also be a small lightbulb attached to the door panel, if this is the case, simply twist the socket and pull it out of the door panel. Do not pull hard or direclty straight outward as you could possibly damage the door panel. Lifting the door panel aligns the l brackets with the holes so you can lift up and the out and the door panel will come right off. It is basically sitting in place with a bunch of plastic l brackets that fit into little holes. Once all of the screws are removed, simply lift up and out on the entire door panel and it should come right off.NOTE: Their may also be 2 screws at the very base of the door panel, look closely and remove if they exist.Next, remove the screws holding the door panel in place, see picture below:.These screws are occaisonally a torx style bit or phillips head. Their is a plastic cover that simply lifts up and then you can see a screw that must be removed. ![]() If you have manual windows, then remove the hand crank. You could also leave it connected and fish it through the hole in the door panel late but it is a little bit difficult. The electrical connectors can be removed simply by pushing the quick disconnect tabs on each plug. Thier is a small plastic clip that releases and then you can lift the back of the entire switch up and then slide it out of the door. Take a small flathead screwdriver and push in on the back center of the switch trim piece.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |